COBB Subaru MAP Sensor Adapter - Cast Manifold

This billet aluminum MAP Sensor Adapter is anodized black with a laser etched "C" logo. 1/8" NPT threads allow for simple, leak-free installation of your choice of pressure sensor. An included o-ring and hardware ensure for leak-free installation into the throttle body.

Most Subarus are equipped with either a 2.5 or 3 bar MAP sensor from the factory which allows accurate reading up to either 21.5psi or 28.8psi (respectively). For vehicles targeting boost values higher than that, an upgraded sensor is required for accurate measurement and boost control. This billet aluminum adapter allows for OEM like fitment of aftermarket sensors that use 1/8" NPT threads.

Vehicle Fitment

2002 - 2007 Subaru WRX

2004+ Subaru STI

2004 - 2008 Subaru Forester

WARNING: Operating, servicing and maintaining a passenger vehicle or off-road vehicle can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. To minimize exposure, avoid breathing exhaust, do not idle the engine except as necessary, service your vehicle in a well-ventilated area and wear gloves or wash your hands frequently when servicing your vehicle. For more information go to https://www.P65Warnings.ca.gov/passenger-vehicle.