The 1-piece driveshaft for the Subaru WRX is a complete 2.75" Carbon Fiber shaft that is approximately 1/2 the weight of the factory 2-piece driveshaft. The 1-piece carbon shaft features larger, replaceable u-joints and can handle about 800WHP and 180 MPH. We had the tubing custom wound with a high modulus fiber to ensure the strength while making it small enough to clear everything under the car. All of the factory shields, plates and covers can be used without any alteration to the car at all. The ends are made from 6061-T6 aluminum and that shaft weighs a mere 12.2lbs. Not only will the car feel more responsive but it will also make a noticeable difference on the noise level in the car.
By removing the factory 2-piece shaft and installing a single shaft, the car will feel more responsive due to the lighter weight of the shaft and also the fact that the hanger bearing is not moving up and down during acceleration. Available for most popular motor/trans combinations, if you don’t see yours listed, custom shafts are also available.
**Open Box Item: Sold as is condition is like New**
- 2008-2014 WRX - 6-SPD Conversion
WARNING: Operating, servicing and maintaining a passenger vehicle or off-road vehicle can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. To minimize exposure, avoid breathing exhaust, do not idle the engine except as necessary, service your vehicle in a well-ventilated area and wear gloves or wash your hands frequently when servicing your vehicle. For more information go to https://www.P65Warnings.ca.gov/passenger-vehicle.