Driveshaft Shop Carbon Fiber Driveshaft - Manual Transmission (13-20 BRZ)

The 1-piece driveshaft is a complete 2.75” Carbon Fiber shaft that is approximately 1/2 the weight of the factory 2-piece driveshaft. The 1-piece carbon shaft features larger, replaceable u-joints and can handle about 850WHP. We had the tubing custom wound with a high modulus fiber to ensure the strength while making it small enough to clear everything under the car. All of the factory shields, plates and covers can be used without any alteration to the car at all. Not only will the car feel more responsive but it will also make a noticeable difference on the noise level in the car.

By removing the factory 2-piece shaft and installing a single shaft, the car will feel more responsive due to the lighter weight of the shaft and also the fact that the hanger bearing is not moving up and down during acceleration. Available for most popular motor/trans combinations, if you don’t see yours listed, custom shafts are also available.

Please Note: May have interference with aftermarket short throw shifters.